FrostList

When to Prep Your Snow Blower in Edina, MN

ON TRACK127 days until first 1″ snow (estimated)Nov 15

In Edina, get the snow blower serviced by October 25, about three weeks before the first plowable snow the normals put near November 15; do the fuel, oil, plug, and a test start early. The early-to-late range spans roughly 27 days, so treat the median as a midpoint, not a promise.

OUTLOOK

Typical first first 1″ snow (estimated) near Nov 15; local deadline about Oct 25. The live 10-day outlook loads here.

Local freeze dates for Edina

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Oct 1Oct 18Oct 31
28°F (hard freeze)Oct 15Oct 29Nov 11
24°F (severe)Oct 25Nov 6Nov 19

NOAA station: Minneapolis/St Paul AP · 5.9 mi away · 872 ft elevation · est. first 1" snow: Nov 15.

Numbers for Edina come from Minneapolis/St Paul AP, 5.9 miles away at 872 feet, where the medians fall 32°F by Oct 18, 28°F by Oct 29, 24°F by Nov 6. Year to year the 28°F date has ranged from Oct 15 to Nov 11 — about 27 days apart. Spring's last 32°F freeze clears around Apr 23. Snowfall averages 51 inches a year, first reaching an inch near November.

Edina usually sees its first 32°F night about Oct 18, with the first 28°F hard freeze close behind near Oct 29. The 32°F date swings from Oct 1 at its earliest to Oct 31 at its latest, near 30 days. The last spring freeze averages Apr 23 and as late as May 7, which sets the safe window for reopening outdoor water and de-winterizing gear. Roughly 51 inches of snow fall in an average year, so a clear roof edge and a running snow blower matter as much as the freeze itself.

Your snow blower checklist

  1. Change the oil and check the level; cold-thickened old oil makes the engine harder to pull over.
  2. Drain summer-old fuel and refill with fresh gasoline, then add stabilizer so it stays good through the season.
    Helpful gear: Fuel stabilizer — Recommended pick
  3. Inspect the spark plug and swap it if the tip is dark or worn; a fresh plug is a cheap no-start fix.
    Helpful gear: Replacement spark plug — Recommended pick
  4. Check the shear pins and keep spares on hand — they break on purpose to protect the auger gearbox.
    Helpful gear: Shear pin kit — Recommended pick
  5. Set the tire pressure to the 15–20 psi range printed on the sidewall so the machine tracks straight.
  6. Lubricate the auger and chute controls and confirm the chute rotates and tilts freely.
  7. Do a test start now, well before the first storm, so any repair happens before the shop lines form.
  8. Keep a good shovel by the door for steps and for the day the machine still will not cooperate.
    Helpful gear: Backup snow shovel — Recommended pick

What to have on hand

Fuel stabilizer
Additive that keeps stored gasoline from gumming the carburetor.
Recommended pick
Shear pin kit
Spare pins that break on purpose to save the auger gearbox.
Recommended pick
Replacement spark plug
A fresh plug is the cheapest fix for a hard-starting engine.
Recommended pick
Backup snow shovel
A good shovel for steps and the day the machine will not start.
Recommended pick

What this means locally

Edina freezes close to Bloomington (Nov 15) and close to St. Louis Park (Nov 15) — a reminder that even nearby towns differ by days. Statewide, Minnesota prep dates run Sep 24 through Oct 25, which is why Edina gets its own number rather than a Minnesota-wide average. The same freeze also decides when to keep your roof edge clear and protect your pipes.

Other winter jobs in Edina

Every task below is dated to Edina's own freeze and snow normals.

Sprinklers → Oct 19Frozen pipes → Oct 1Ice dams → Oct 16Car battery → Oct 29Sump pump → Apr 23RV → Oct 19Boat → Oct 22Motorcycle → Oct 18

See the full Edina winter checklist, in order →

Frequently asked questions

When should I get my snow blower serviced?
Service the machine about three weeks before the first plowable snow, which here is estimated near Nov 15 from NOAA snowfall normals. Servicing early means fresh fuel, oil, a good plug, and spare shear pins are in place before repair shops fill up after the first storm.
How old can gas be in a snow blower?
Untreated gasoline can start to break down in about 30 days, gumming the carburetor and making the engine hard to start. Use fresh fuel and add stabilizer if it will sit, or run the tank dry at the end of the season. Ethanol-blend fuel is especially prone to trouble in small engines.
Why won't my snow blower start after summer?
The usual culprit is stale fuel that varnished the carburetor over the off-season. A fouled spark plug, old oil, or a clogged fuel line can also be to blame. Draining old gas, fitting a fresh plug, and adding clean, stabilized fuel solves most first-storm no-starts.
What are shear pins and how many spares do I need?
Shear pins are small bolts that connect the auger to its shaft and are designed to break if the auger hits something solid, protecting the gearbox. Keep at least two to four spares and the right size for your model, since a broken pin in mid-storm stops the machine until you replace it.
Electric vs gas snow blower for Edina?
Electric and battery machines are quiet, low-maintenance, and fine for lighter, shallower snow and smaller drives. Gas machines handle deep, heavy, wet snow and long driveways better. Match the choice to your typical snowfall and driveway length; heavier-snow areas usually favor gas.
How many inches of snow before using a snow blower?
Most single-stage blowers work best on about two inches or more; below that a shovel or broom is faster. Two-stage machines handle deeper accumulations. Clearing in stages during a big storm, rather than waiting for it to finish, keeps the load on the machine manageable.

Data: NOAA 1991–2020 normals via Minneapolis/St Paul AP, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.