FrostList

When to Prep Your Snow Blower in Allentown, PA

ON TRACK157 days until first 1″ snow (estimated)Dec 15

The first plowable snow in Allentown is estimated near December 15 (NOAA snowfall normals), so service the machine by November 24 — roughly three weeks ahead — with fresh, stabilized fuel and a test start. Plan for the early end: the one-in-ten date lands about 16 days before the median.

OUTLOOK

Typical first first 1″ snow (estimated) near Dec 15; local deadline about Nov 24. The live 10-day outlook loads here.

Local freeze dates for Allentown

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Oct 8Oct 24Nov 6
28°F (hard freeze)Oct 19Nov 4Nov 18
24°F (severe)Nov 1Nov 16Dec 3

NOAA station: Allentown Intl AP · 3.6 mi away · 390 ft elevation · est. first 1" snow: Dec 15.

Allentown draws its numbers from Allentown Intl AP, 390 feet up and 3.6 miles away. Its median first-freeze dates are 32°F by Oct 24, 28°F by Nov 4, 24°F by Nov 16. The 28°F freeze has come as early as Oct 19 and as late as Nov 18, a 30-day spread. Spring's last 32°F freeze clears around Apr 20. Snowfall averages 33 inches a year, first reaching an inch near December.

Expect the first frost near Oct 24 in Allentown and the first hard freeze by about Nov 4. That first freezing night has ranged from Oct 8 to Nov 6, roughly a 29-day spread. On the spring side, the last 32°F freeze clears around Apr 20 and as late as May 6 — the green light for reopening water and de-winterizing. With around 33 inches of snow annually, plan for a handful of plowable storms each winter.

Your snow blower checklist

  1. Change the oil and check the level; cold-thickened old oil makes the engine harder to pull over.
  2. Drain summer-old fuel and refill with fresh gasoline, then add stabilizer so it stays good through the season.
    Helpful gear: Fuel stabilizer — Recommended pick
  3. Inspect the spark plug and swap it if the tip is dark or worn; a fresh plug is a cheap no-start fix.
    Helpful gear: Replacement spark plug — Recommended pick
  4. Check the shear pins and keep spares on hand — they break on purpose to protect the auger gearbox.
    Helpful gear: Shear pin kit — Recommended pick
  5. Set the tire pressure to the 15–20 psi range printed on the sidewall so the machine tracks straight.
  6. Lubricate the auger and chute controls and confirm the chute rotates and tilts freely.
  7. Do a test start now, well before the first storm, so any repair happens before the shop lines form.
  8. Keep a good shovel by the door for steps and for the day the machine still will not cooperate.
    Helpful gear: Backup snow shovel — Recommended pick

What to have on hand

Fuel stabilizer
Additive that keeps stored gasoline from gumming the carburetor.
Recommended pick
Shear pin kit
Spare pins that break on purpose to save the auger gearbox.
Recommended pick
Replacement spark plug
A fresh plug is the cheapest fix for a hard-starting engine.
Recommended pick
Backup snow shovel
A good shovel for steps and the day the machine will not start.
Recommended pick

What this means locally

Compared with nearby cities, Allentown's first-freeze date near Dec 15 sits close to Bethlehem (Dec 15) and close to Reading (Dec 15). Pennsylvania's deadlines span Oct 25 to Nov 24 statewide — one date for all of Pennsylvania would be off by weeks for Allentown. Once you know Allentown's freeze date, use it to keep your roof edge clear and protect your pipes too.

Other winter jobs in Allentown

Every task below is dated to Allentown's own freeze and snow normals.

Sprinklers → Oct 25Frozen pipes → Oct 8Ice dams → Nov 15Car battery → Nov 4Sump pump → Apr 20RV → Oct 25Boat → Oct 28Motorcycle → Oct 24

See the full Allentown winter checklist, in order →

Frequently asked questions

When should I get my snow blower serviced?
Service the machine about three weeks before the first plowable snow, which here is estimated near Dec 15 from NOAA snowfall normals. Servicing early means fresh fuel, oil, a good plug, and spare shear pins are in place before repair shops fill up after the first storm.
How old can gas be in a snow blower?
Untreated gasoline can start to break down in about 30 days, gumming the carburetor and making the engine hard to start. Use fresh fuel and add stabilizer if it will sit, or run the tank dry at the end of the season. Ethanol-blend fuel is especially prone to trouble in small engines.
Why won't my snow blower start after summer?
The usual culprit is stale fuel that varnished the carburetor over the off-season. A fouled spark plug, old oil, or a clogged fuel line can also be to blame. Draining old gas, fitting a fresh plug, and adding clean, stabilized fuel solves most first-storm no-starts.
What are shear pins and how many spares do I need?
Shear pins are small bolts that connect the auger to its shaft and are designed to break if the auger hits something solid, protecting the gearbox. Keep at least two to four spares and the right size for your model, since a broken pin in mid-storm stops the machine until you replace it.
Electric vs gas snow blower for Allentown?
Electric and battery machines are quiet, low-maintenance, and fine for lighter, shallower snow and smaller drives. Gas machines handle deep, heavy, wet snow and long driveways better. Match the choice to your typical snowfall and driveway length; heavier-snow areas usually favor gas.
How many inches of snow before using a snow blower?
Most single-stage blowers work best on about two inches or more; below that a shovel or broom is faster. Two-stage machines handle deeper accumulations. Clearing in stages during a big storm, rather than waiting for it to finish, keeps the load on the machine manageable.

Data: NOAA 1991–2020 normals via Allentown Intl AP, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.