FrostList

When to Test Your Sump Pump in Cedar Park, TX

SEASON PASSED243 days until spring thaw test (last 32°F)Mar 11

Check your Cedar Park sump pump before meltwater arrives — the last spring freeze averages March 11 — and again ahead of fall storms; the bucket test takes two minutes. Plan for the early end: the one-in-ten date lands about 21 days before the median.

OUTLOOK

Typical first spring thaw test (last 32°F) near Mar 11; local deadline about Mar 11. The live 10-day outlook loads here.

Local freeze dates for Cedar Park

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Nov 3Nov 20Dec 9
28°F (hard freeze)Nov 12Dec 3Dec 29
24°F (severe)Nov 26Dec 20Jan 27

NOAA station: Austin Great Hills · 7.0 mi away · 880 ft elevation.

Cedar Park draws its numbers from Austin Great Hills, 880 feet up and 7.0 miles away. Its median first-freeze dates are 32°F by Nov 20, 28°F by Dec 3, 24°F by Dec 20. That hard freeze has landed anywhere from Nov 12 to Dec 29, a swing of roughly 47 days. Spring's last 32°F freeze clears around Mar 11.

Expect the first frost near Nov 20 in Cedar Park and the first hard freeze by about Dec 3. That first freezing night has ranged from Nov 3 to Dec 9, roughly a 36-day spread. On the spring side, the last 32°F freeze clears around Mar 11 and as late as Mar 29 — the green light for reopening water and de-winterizing. With almost no snow in a normal year, cold — not plowing — sets the calendar, and it centers on Mar 11.

Your sump pump checklist

  1. Pour about five gallons of water into the pit slowly and watch the float rise, the pump start, and the water drop.
    Helpful gear: Water level alarm — Recommended pick
  2. Confirm the discharge line carries water 10–20 feet from the foundation and does not drain back into the pit.
    Helpful gear: Sump check valve — Recommended pick
  3. Clear the inlet screen and the pit of gravel and debris that can jam the float or the impeller.
  4. Check the check valve for a firm click; a failed valve lets discharged water fall back and short-cycle the pump.
  5. Add a battery backup pump so the system still runs when a storm knocks out the power.
    Helpful gear: Battery backup sump pump — Recommended pick
  6. Test the backup on battery power and note the install date; batteries usually need replacing every few years.
  7. If the primary pump is 7–10 years old, keep a replacement on the shelf before it fails mid-storm.
    Helpful gear: Replacement primary pump — Recommended pick
  8. Remember that flood insurance and most homeowner policies treat pump failure separately — read your coverage.

What to have on hand

Battery backup sump pump
Second pump that runs when the power goes out mid-storm.
Recommended pick
Water level alarm
Loud sensor that warns you before the pit overflows.
Recommended pick
Sump check valve
One-way valve that stops discharged water from draining back.
Recommended pick
Replacement primary pump
A ready spare for a pump nearing the end of its life.
Recommended pick

What this means locally

Against its neighbors, Cedar Park (first freeze Mar 11) runs close to Round Rock (Mar 11) and later than Georgetown (Mar 6). Across Texas, local prep deadlines in our data range from Jan 8 to Apr 15, so a statewide rule of thumb would miss Cedar Park by weeks. In Cedar Park, that same cold is your cue to protect your pipes.

Other winter jobs in Cedar Park

Every task below is dated to Cedar Park's own freeze and snow normals.

Sprinklers → Nov 23Frozen pipes → Nov 3Car battery → Dec 3RV → Nov 23Boat → Nov 26Motorcycle → Nov 20

See the full Cedar Park winter checklist, in order →

Frequently asked questions

How do I test my sump pump before heavy rain?
Pour about five gallons of water into the pit slowly and watch the float rise, the pump switch on, and the water level drop. Confirm the discharge carries water well away from the foundation. Doing this before the wet season, and again in spring near the last freeze around Mar 11, catches problems early.
How often should a sump pump run?
It varies with your water table and weather; some pumps cycle every few minutes during a storm and sit idle for weeks in dry spells. Frequent cycling with no rain can signal a stuck float, a failed check valve, or groundwater seeping in. Occasional running during wet weather is normal.
How long do sump pumps last?
A typical sump pump lasts about 7 to 10 years, though hard-working pumps wear out sooner. If yours is near that age, keep a replacement on hand so a mid-storm failure does not leave the pit unattended. Testing it seasonally tells you more than age alone.
Do I need a battery backup sump pump?
If your basement floods when the power goes out, yes — storms that overwhelm the pit are exactly when the grid tends to fail. A battery backup runs the pump through an outage, which is the single most common cause of a wet basement during heavy weather. Test the backup on battery power, too.
Does insurance cover sump pump failure?
Standard homeowner policies and federal flood insurance often exclude damage from a sump pump that fails or is overwhelmed. A separate water-backup or sump-failure rider may be available. Read your policy before a storm, because assumptions about coverage are a common and costly surprise.
Why is my sump pump running with no rain?
A high water table, snowmelt, or groundwater seepage can keep the pit filling even in dry weather. A pump that runs constantly may also have a stuck float switch or a check valve that lets discharged water fall back into the pit. Check the float and the valve first.

Data: NOAA 1991–2020 normals via Austin Great Hills, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.