FrostList

When to Test Your Sump Pump in Pearland, TX

SEASON PASSED204 days until spring thaw test (last 32°F)Jan 31

Check your Pearland sump pump before meltwater arrives — the last spring freeze averages January 31 — and again ahead of fall storms; the bucket test takes two minutes. Cold deepens quickly here — only about 12 days separate the first frost from that hard freeze.

OUTLOOK

Typical first spring thaw test (last 32°F) near Jan 31; local deadline about Jan 31. The live 10-day outlook loads here.

Local freeze dates for Pearland

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Nov 28Dec 27Jan 28
28°F (hard freeze)Dec 14Jan 8Feb 4
24°F (severe)Dec 26Jan 9Feb 1

NOAA station: Houston Clover Fld · 4.1 mi away · 44 ft elevation.

For Pearland, the nearest NOAA station with freeze data is Houston Clover Fld, 4.1 miles out at 44 feet. Median first-freeze dates there run 32°F by Dec 27, 28°F by Jan 8, 24°F by Jan 9. Year to year the 28°F date has ranged from Dec 14 to Feb 4 — about 52 days apart. Spring's last 32°F freeze clears around Jan 31.

In Pearland, freezing nights (32°F) typically begin around Dec 27 and the first hard freeze (28°F) follows near Jan 8. That first freezing night has ranged from Nov 28 to Jan 28, roughly a 61-day spread. On the spring side, the last 32°F freeze clears around Jan 31 and as late as Mar 5 — the green light for reopening water and de-winterizing. With almost no snow in a normal year, cold — not plowing — sets the calendar, and it centers on Jan 31.

Your sump pump checklist

  1. Pour about five gallons of water into the pit slowly and watch the float rise, the pump start, and the water drop.
    Helpful gear: Water level alarm — Recommended pick
  2. Confirm the discharge line carries water 10–20 feet from the foundation and does not drain back into the pit.
    Helpful gear: Sump check valve — Recommended pick
  3. Clear the inlet screen and the pit of gravel and debris that can jam the float or the impeller.
  4. Check the check valve for a firm click; a failed valve lets discharged water fall back and short-cycle the pump.
  5. Add a battery backup pump so the system still runs when a storm knocks out the power.
    Helpful gear: Battery backup sump pump — Recommended pick
  6. Test the backup on battery power and note the install date; batteries usually need replacing every few years.
  7. If the primary pump is 7–10 years old, keep a replacement on the shelf before it fails mid-storm.
    Helpful gear: Replacement primary pump — Recommended pick
  8. Remember that flood insurance and most homeowner policies treat pump failure separately — read your coverage.

What to have on hand

Battery backup sump pump
Second pump that runs when the power goes out mid-storm.
Recommended pick
Water level alarm
Loud sensor that warns you before the pit overflows.
Recommended pick
Sump check valve
One-way valve that stops discharged water from draining back.
Recommended pick
Replacement primary pump
A ready spare for a pump nearing the end of its life.
Recommended pick

What this means locally

Compared with nearby cities, Pearland's first-freeze date near Jan 31 sits close to Friendswood (Jan 31) and close to Pasadena (Feb 2). Texas's deadlines span Jan 8 to Apr 15 statewide — one date for all of Texas would be off by weeks for Pearland. Once you know Pearland's freeze date, use it to protect your pipes too.

Other winter jobs in Pearland

Every task below is dated to Pearland's own freeze and snow normals.

Sprinklers → Dec 29Frozen pipes → Nov 28Car battery → Jan 8RV → Dec 29Boat → Jan 1Motorcycle → Dec 27

See the full Pearland winter checklist, in order →

Frequently asked questions

How do I test my sump pump before heavy rain?
Pour about five gallons of water into the pit slowly and watch the float rise, the pump switch on, and the water level drop. Confirm the discharge carries water well away from the foundation. Doing this before the wet season, and again in spring near the last freeze around Jan 31, catches problems early.
How often should a sump pump run?
It varies with your water table and weather; some pumps cycle every few minutes during a storm and sit idle for weeks in dry spells. Frequent cycling with no rain can signal a stuck float, a failed check valve, or groundwater seeping in. Occasional running during wet weather is normal.
How long do sump pumps last?
A typical sump pump lasts about 7 to 10 years, though hard-working pumps wear out sooner. If yours is near that age, keep a replacement on hand so a mid-storm failure does not leave the pit unattended. Testing it seasonally tells you more than age alone.
Do I need a battery backup sump pump?
If your basement floods when the power goes out, yes — storms that overwhelm the pit are exactly when the grid tends to fail. A battery backup runs the pump through an outage, which is the single most common cause of a wet basement during heavy weather. Test the backup on battery power, too.
Does insurance cover sump pump failure?
Standard homeowner policies and federal flood insurance often exclude damage from a sump pump that fails or is overwhelmed. A separate water-backup or sump-failure rider may be available. Read your policy before a storm, because assumptions about coverage are a common and costly surprise.
Why is my sump pump running with no rain?
A high water table, snowmelt, or groundwater seepage can keep the pit filling even in dry weather. A pump that runs constantly may also have a stuck float switch or a check valve that lets discharged water fall back into the pit. Check the float and the valve first.

Data: NOAA 1991–2020 normals via Houston Clover Fld, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.