FrostList

When to Test Your Sump Pump in Logan, UT

SEASON PASSED301 days until spring thaw test (last 32°F)May 8

Check your Logan sump pump before meltwater arrives — the last spring freeze averages May 8 — and again ahead of fall storms; the bucket test takes two minutes. Plan for the early end: the one-in-ten date lands about 15 days before the median.

OUTLOOK

Typical first spring thaw test (last 32°F) near May 8; local deadline about May 8. The live 10-day outlook loads here.

Local freeze dates for Logan

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Sep 18Oct 2Oct 15
28°F (hard freeze)Sep 29Oct 14Oct 26
24°F (severe)Oct 13Oct 26Nov 9

NOAA station: Logan Radio Kvnu · 1.2 mi away · 4,475 ft elevation.

Logan draws its numbers from Logan Radio Kvnu, 4,475 feet up and 1.2 miles away. Its median first-freeze dates are 32°F by Oct 2, 28°F by Oct 14, 24°F by Oct 26. The 28°F freeze has come as early as Sep 29 and as late as Oct 26, a 27-day spread. Spring's last 32°F freeze clears around May 8. Snowfall averages 44 inches a year, first reaching an inch near November.

Expect the first frost near Oct 2 in Logan and the first hard freeze by about Oct 14. That first freezing night has ranged from Sep 18 to Oct 15, roughly a 27-day spread. On the spring side, the last 32°F freeze clears around May 8 and as late as Jun 2 — the green light for reopening water and de-winterizing. Snow totals near 44 inches a year mean plowing and ice-dam control share the winter to-do list here.

Your sump pump checklist

  1. Pour about five gallons of water into the pit slowly and watch the float rise, the pump start, and the water drop.
    Helpful gear: Water level alarm — Recommended pick
  2. Confirm the discharge line carries water 10–20 feet from the foundation and does not drain back into the pit.
    Helpful gear: Sump check valve — Recommended pick
  3. Clear the inlet screen and the pit of gravel and debris that can jam the float or the impeller.
  4. Check the check valve for a firm click; a failed valve lets discharged water fall back and short-cycle the pump.
  5. Add a battery backup pump so the system still runs when a storm knocks out the power.
    Helpful gear: Battery backup sump pump — Recommended pick
  6. Test the backup on battery power and note the install date; batteries usually need replacing every few years.
  7. If the primary pump is 7–10 years old, keep a replacement on the shelf before it fails mid-storm.
    Helpful gear: Replacement primary pump — Recommended pick
  8. Remember that flood insurance and most homeowner policies treat pump failure separately — read your coverage.

What to have on hand

Battery backup sump pump
Second pump that runs when the power goes out mid-storm.
Recommended pick
Water level alarm
Loud sensor that warns you before the pit overflows.
Recommended pick
Sump check valve
One-way valve that stops discharged water from draining back.
Recommended pick
Replacement primary pump
A ready spare for a pump nearing the end of its life.
Recommended pick

What this means locally

Compared with nearby cities, Logan's first-freeze date near May 8 sits later than Ogden (Apr 21) and later than Roy (Apr 22). Utah's deadlines span Mar 14 to May 8 statewide — one date for all of Utah would be off by weeks for Logan. Once you know Logan's freeze date, use it to protect your pipes and watch your roof too.

Other winter jobs in Logan

Every task below is dated to Logan's own freeze and snow normals.

Sprinklers → Oct 4Frozen pipes → Sep 18Ice dams → Oct 16Car battery → Oct 14Snow blower → Oct 25RV → Oct 4Boat → Oct 7Motorcycle → Oct 2

See the full Logan winter checklist, in order →

Frequently asked questions

How do I test my sump pump before heavy rain?
Pour about five gallons of water into the pit slowly and watch the float rise, the pump switch on, and the water level drop. Confirm the discharge carries water well away from the foundation. Doing this before the wet season, and again in spring near the last freeze around May 8, catches problems early.
How often should a sump pump run?
It varies with your water table and weather; some pumps cycle every few minutes during a storm and sit idle for weeks in dry spells. Frequent cycling with no rain can signal a stuck float, a failed check valve, or groundwater seeping in. Occasional running during wet weather is normal.
How long do sump pumps last?
A typical sump pump lasts about 7 to 10 years, though hard-working pumps wear out sooner. If yours is near that age, keep a replacement on hand so a mid-storm failure does not leave the pit unattended. Testing it seasonally tells you more than age alone.
Do I need a battery backup sump pump?
If your basement floods when the power goes out, yes — storms that overwhelm the pit are exactly when the grid tends to fail. A battery backup runs the pump through an outage, which is the single most common cause of a wet basement during heavy weather. Test the backup on battery power, too.
Does insurance cover sump pump failure?
Standard homeowner policies and federal flood insurance often exclude damage from a sump pump that fails or is overwhelmed. A separate water-backup or sump-failure rider may be available. Read your policy before a storm, because assumptions about coverage are a common and costly surprise.
Why is my sump pump running with no rain?
A high water table, snowmelt, or groundwater seepage can keep the pit filling even in dry weather. A pump that runs constantly may also have a stuck float switch or a check valve that lets discharged water fall back into the pit. Check the float and the valve first.

Data: NOAA 1991–2020 normals via Logan Radio Kvnu, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.