FrostList

When to Winterize Sprinklers in Clovis, CA

ON TRACK166 days until first 28°F freezeDec 24

Aim to winterize your sprinkler system in Clovis by December 14, roughly a week and a half before the median first 28°F freeze of December 24, which one fall in ten shows up by December 7. Year to year the date swings about 39 days, which is why the live outlook beats the calendar.

OUTLOOK

Typical first first 28°F freeze near Dec 24; local deadline about Dec 14. The live 10-day outlook loads here.

Local freeze dates for Clovis

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Nov 29Dec 14Jan 12
28°F (hard freeze)Dec 7Dec 24Jan 15

NOAA station: Fresno Yosemite Intl AP · 3.3 mi away · 333 ft elevation.

Numbers for Clovis come from Fresno Yosemite Intl AP, 3.3 miles away at 333 feet, where the medians fall 32°F by Dec 14, 28°F by Dec 24. Year to year the 28°F date has ranged from Dec 7 to Jan 15 — about 39 days apart. Spring's last 32°F freeze clears around Jan 14.

The freeze arrives in two steps in Clovis: 32°F around Dec 14, then a hard 28°F near Dec 24. Year to year, the first 32°F night has fallen anywhere from Nov 29 to Jan 12 — about 44 days apart. Spring's final freeze lands near Jan 14 and as late as Feb 11, so that is when outdoor water and stored gear can safely come back online. Measurable snow is rare, so the freeze near Jan 14 — not snow load — drives the local prep list.

Your sprinklers checklist

  1. Shut off the irrigation water supply at the main valve and, if you have one, the dedicated sprinkler shutoff inside the house.
  2. Turn off the controller or set it to the "rain" mode so valves do not open while the system is dry.
  3. Drain the mainline using the manual, automatic, or blow-out method your system was built for; most pros prefer a blow-out.
  4. Connect a compressor to the blow-out port through a proper adapter and run 40–80 psi, one zone at a time, until the heads mist and clear.
    Helpful gear: Air compressor blow-out adapter — Recommended pick
  5. Insulate the backflow preventer and any above-ground valves; this brass assembly is usually the first part to crack.
    Helpful gear: Insulated backflow preventer cover — Recommended pick
  6. Cap outdoor hose bibs with foam covers after the hoses come off so the last exposed fittings stay protected.
    Helpful gear: Foam outdoor faucet covers — Recommended pick
  7. Open the backflow test cocks a quarter turn so any trapped water has room to expand.
  8. Log the date and the psi you used; you will want the reference next fall.

What to have on hand

Air compressor blow-out adapter
Quick-connect fitting that mates a shop compressor to your irrigation line.
Recommended pick
Insulated backflow preventer cover
Pouch that shields the above-ground backflow valve from early frost.
Recommended pick
Foam outdoor faucet covers
Slip-on domes that protect hose bibs after you drain them.
Recommended pick
Portable air compressor
A modest pancake unit moves enough air to clear most home zones.
Recommended pick

What this means locally

Compared with nearby cities, Clovis's first-freeze date near Dec 24 sits close to Fresno (Dec 24) and later than Madera (Dec 10). California's deadlines span Jan 6 to Dec 27 statewide — one date for all of California would be off by weeks for Clovis. Once you know Clovis's freeze date, use it to protect your indoor pipes and winterize an RV if you own one too.

Other winter jobs in Clovis

Every task below is dated to Clovis's own freeze and snow normals.

Frozen pipes → Nov 29Car battery → Dec 24Sump pump → Jan 14RV → Dec 14Boat → Dec 17Motorcycle → Dec 14

See the full Clovis winter checklist, in order →

Frequently asked questions

What temperature freezes sprinkler pipes?
Standing water in shallow lines and the backflow assembly can start to freeze once air temperatures drop into the mid-20s for several hours. Buried mains are slower, but the exposed brass backflow preventer and above-ground valves are the parts that crack first, which is why the deadline is tied to the first 28°F freeze, not the first frost.
Do I need to blow out my sprinklers or just drain them?
It depends on how the system was installed. Manual or automatic drains work if the lines were pitched to low points. Most irrigation pros recommend a compressed-air blow-out because it clears water that drains miss, especially in flat yards. If you are unsure how your system drains, a blow-out is the safer choice.
What happens if I don't winterize my sprinkler system?
Water left in the lines expands as it freezes and can split the backflow preventer, crack valves, or break fittings. Repairs to a backflow assembly commonly run more than the cost of a blow-out. The damage often is not visible until you turn the system on in spring and find leaks.
How much does a sprinkler blowout cost?
A professional blow-out typically costs somewhere in the range of a modest service call, depending on the number of zones and your region. Buying an adapter and using your own compressor costs less over time, but you need enough air volume to clear each zone. Prices rise once the first freeze warnings appear, so book early.
When should I turn my sprinklers back on in Clovis?
Wait until the last spring freeze has passed, which averages around Jan 14 here in the 1991–2020 normals. Turning the system on too early risks refreezing a charged line. Open the main slowly to avoid a pressure surge, then walk each zone to check for winter damage before you rely on the schedule.
Can I winterize sprinklers myself?
Draining and insulating are within reach for most homeowners. A blow-out is doable if you own a compressor that moves enough air and you use a proper adapter, working one zone at a time at safe pressure. If your system lacks a clear blow-out port or you are not confident, hiring a pro once is a reasonable call.

Data: NOAA 1991–2020 normals via Fresno Yosemite Intl AP, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.