FrostList

When to Winterize Sprinklers in Hurst, TX

ON TRACK145 days until first 28°F freezeDec 3

Aim to winterize your sprinkler system in Hurst by November 23, roughly a week and a half before the median first 28°F freeze of December 3, which one fall in ten shows up by November 10. The early-to-late range spans roughly 45 days, so treat the median as a midpoint, not a promise.

OUTLOOK

Typical first first 28°F freeze near Dec 3; local deadline about Nov 23. The live 10-day outlook loads here.

Local freeze dates for Hurst

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Oct 31Nov 20Dec 10
28°F (hard freeze)Nov 10Dec 3Dec 25
24°F (severe)Nov 22Dec 16Jan 16

NOAA station: Arlington Six Flags · 7.3 mi away · 536 ft elevation.

For Hurst, the nearest NOAA station with freeze data is Arlington Six Flags, 7.3 miles out at 536 feet. Median first-freeze dates there run 32°F by Nov 20, 28°F by Dec 3, 24°F by Dec 16. Year to year the 28°F date has ranged from Nov 10 to Dec 25 — about 45 days apart. Spring's last 32°F freeze clears around Mar 9. Snowfall averages 1 inches a year.

Hurst usually sees its first 32°F night about Nov 20, with the first 28°F hard freeze close behind near Dec 3. The 32°F date swings from Oct 31 at its earliest to Dec 10 at its latest, near 40 days. The last spring freeze averages Mar 9 and as late as Apr 2, which sets the safe window for reopening outdoor water and de-winterizing gear. Snow barely registers here; the freeze date, around Mar 9, is the one that matters.

Your sprinklers checklist

  1. Shut off the irrigation water supply at the main valve and, if you have one, the dedicated sprinkler shutoff inside the house.
  2. Turn off the controller or set it to the "rain" mode so valves do not open while the system is dry.
  3. Drain the mainline using the manual, automatic, or blow-out method your system was built for; most pros prefer a blow-out.
  4. Connect a compressor to the blow-out port through a proper adapter and run 40–80 psi, one zone at a time, until the heads mist and clear.
    Helpful gear: Air compressor blow-out adapter — Recommended pick
  5. Insulate the backflow preventer and any above-ground valves; this brass assembly is usually the first part to crack.
    Helpful gear: Insulated backflow preventer cover — Recommended pick
  6. Cap outdoor hose bibs with foam covers after the hoses come off so the last exposed fittings stay protected.
    Helpful gear: Foam outdoor faucet covers — Recommended pick
  7. Open the backflow test cocks a quarter turn so any trapped water has room to expand.
  8. Log the date and the psi you used; you will want the reference next fall.

What to have on hand

Air compressor blow-out adapter
Quick-connect fitting that mates a shop compressor to your irrigation line.
Recommended pick
Insulated backflow preventer cover
Pouch that shields the above-ground backflow valve from early frost.
Recommended pick
Foam outdoor faucet covers
Slip-on domes that protect hose bibs after you drain them.
Recommended pick
Portable air compressor
A modest pancake unit moves enough air to clear most home zones.
Recommended pick

What this means locally

Compared with nearby cities, Hurst's first-freeze date near Dec 3 sits close to Bedford (Dec 3) and close to North Richland Hills (Dec 1). Texas's deadlines span Oct 27 to Dec 29 statewide — one date for all of Texas would be off by weeks for Hurst. Once you know Hurst's freeze date, use it to protect your indoor pipes and winterize an RV if you own one too.

Other winter jobs in Hurst

Every task below is dated to Hurst's own freeze and snow normals.

Frozen pipes → Oct 31Car battery → Dec 3Sump pump → Mar 9RV → Nov 23Boat → Nov 26Motorcycle → Nov 20

See the full Hurst winter checklist, in order →

Frequently asked questions

What temperature freezes sprinkler pipes?
Standing water in shallow lines and the backflow assembly can start to freeze once air temperatures drop into the mid-20s for several hours. Buried mains are slower, but the exposed brass backflow preventer and above-ground valves are the parts that crack first, which is why the deadline is tied to the first 28°F freeze, not the first frost.
Do I need to blow out my sprinklers or just drain them?
It depends on how the system was installed. Manual or automatic drains work if the lines were pitched to low points. Most irrigation pros recommend a compressed-air blow-out because it clears water that drains miss, especially in flat yards. If you are unsure how your system drains, a blow-out is the safer choice.
What happens if I don't winterize my sprinkler system?
Water left in the lines expands as it freezes and can split the backflow preventer, crack valves, or break fittings. Repairs to a backflow assembly commonly run more than the cost of a blow-out. The damage often is not visible until you turn the system on in spring and find leaks.
How much does a sprinkler blowout cost?
A professional blow-out typically costs somewhere in the range of a modest service call, depending on the number of zones and your region. Buying an adapter and using your own compressor costs less over time, but you need enough air volume to clear each zone. Prices rise once the first freeze warnings appear, so book early.
When should I turn my sprinklers back on in Hurst?
Wait until the last spring freeze has passed, which averages around Mar 9 here in the 1991–2020 normals. Turning the system on too early risks refreezing a charged line. Open the main slowly to avoid a pressure surge, then walk each zone to check for winter damage before you rely on the schedule.
Can I winterize sprinklers myself?
Draining and insulating are within reach for most homeowners. A blow-out is doable if you own a compressor that moves enough air and you use a proper adapter, working one zone at a time at safe pressure. If your system lacks a clear blow-out port or you are not confident, hiring a pro once is a reasonable call.

Data: NOAA 1991–2020 normals via Arlington Six Flags, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.