FrostList

When to Winterize Sprinklers in St. George, UT

ON TRACK132 days until first 28°F freezeNov 20

St. George's deadline to winterize your sprinkler system is November 10: the local first 28°F freeze runs November 20 on average and November 7 at its earliest (1991–2020 normals). It's a short step from frost to a hard freeze: roughly 10 days on average.

OUTLOOK

Typical first first 28°F freeze near Nov 20; local deadline about Nov 10. The live 10-day outlook loads here.

Local freeze dates for St. George

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Oct 27Nov 10Nov 22
28°F (hard freeze)Nov 7Nov 20Dec 3
24°F (severe)Nov 18Dec 1Dec 18

NOAA station: St George · 2.6 mi away · 2,857 ft elevation.

For St. George, the nearest NOAA station with freeze data is St George, 2.6 miles out at 2,857 feet. Median first-freeze dates there run 32°F by Nov 10, 28°F by Nov 20, 24°F by Dec 1. The 28°F freeze has come as early as Nov 7 and as late as Dec 3, a 26-day spread. Spring's last 32°F freeze clears around Mar 14. Snowfall averages 1 inches a year.

Expect the first frost near Nov 10 in St. George and the first hard freeze by about Nov 20. Year to year, the first 32°F night has fallen anywhere from Oct 27 to Nov 22 — about 26 days apart. Spring's final freeze lands near Mar 14 and as late as Apr 6, so that is when outdoor water and stored gear can safely come back online. Measurable snow is rare, so the freeze near Mar 14 — not snow load — drives the local prep list.

Your sprinklers checklist

  1. Shut off the irrigation water supply at the main valve and, if you have one, the dedicated sprinkler shutoff inside the house.
  2. Turn off the controller or set it to the "rain" mode so valves do not open while the system is dry.
  3. Drain the mainline using the manual, automatic, or blow-out method your system was built for; most pros prefer a blow-out.
  4. Connect a compressor to the blow-out port through a proper adapter and run 40–80 psi, one zone at a time, until the heads mist and clear.
    Helpful gear: Air compressor blow-out adapter — Recommended pick
  5. Insulate the backflow preventer and any above-ground valves; this brass assembly is usually the first part to crack.
    Helpful gear: Insulated backflow preventer cover — Recommended pick
  6. Cap outdoor hose bibs with foam covers after the hoses come off so the last exposed fittings stay protected.
    Helpful gear: Foam outdoor faucet covers — Recommended pick
  7. Open the backflow test cocks a quarter turn so any trapped water has room to expand.
  8. Log the date and the psi you used; you will want the reference next fall.

What to have on hand

Air compressor blow-out adapter
Quick-connect fitting that mates a shop compressor to your irrigation line.
Recommended pick
Insulated backflow preventer cover
Pouch that shields the above-ground backflow valve from early frost.
Recommended pick
Foam outdoor faucet covers
Slip-on domes that protect hose bibs after you drain them.
Recommended pick
Portable air compressor
A modest pancake unit moves enough air to clear most home zones.
Recommended pick

What this means locally

Compared with nearby cities, St. George's first-freeze date near Nov 20 sits about a week ahead of North Las Vegas (Dec 21) and about a week ahead of Henderson (Dec 26). Utah's deadlines span Oct 4 to Nov 10 statewide — one date for all of Utah would be off by weeks for St. George. Once you know St. George's freeze date, use it to protect your indoor pipes and winterize an RV if you own one too.

Other winter jobs in St. George

Every task below is dated to St. George's own freeze and snow normals.

Frozen pipes → Oct 27Car battery → Nov 20Sump pump → Mar 14RV → Nov 10Boat → Nov 13Motorcycle → Nov 10

See the full St. George winter checklist, in order →

Frequently asked questions

What temperature freezes sprinkler pipes?
Standing water in shallow lines and the backflow assembly can start to freeze once air temperatures drop into the mid-20s for several hours. Buried mains are slower, but the exposed brass backflow preventer and above-ground valves are the parts that crack first, which is why the deadline is tied to the first 28°F freeze, not the first frost.
Do I need to blow out my sprinklers or just drain them?
It depends on how the system was installed. Manual or automatic drains work if the lines were pitched to low points. Most irrigation pros recommend a compressed-air blow-out because it clears water that drains miss, especially in flat yards. If you are unsure how your system drains, a blow-out is the safer choice.
What happens if I don't winterize my sprinkler system?
Water left in the lines expands as it freezes and can split the backflow preventer, crack valves, or break fittings. Repairs to a backflow assembly commonly run more than the cost of a blow-out. The damage often is not visible until you turn the system on in spring and find leaks.
How much does a sprinkler blowout cost?
A professional blow-out typically costs somewhere in the range of a modest service call, depending on the number of zones and your region. Buying an adapter and using your own compressor costs less over time, but you need enough air volume to clear each zone. Prices rise once the first freeze warnings appear, so book early.
When should I turn my sprinklers back on in St. George?
Wait until the last spring freeze has passed, which averages around Mar 14 here in the 1991–2020 normals. Turning the system on too early risks refreezing a charged line. Open the main slowly to avoid a pressure surge, then walk each zone to check for winter damage before you rely on the schedule.
Can I winterize sprinklers myself?
Draining and insulating are within reach for most homeowners. A blow-out is doable if you own a compressor that moves enough air and you use a proper adapter, working one zone at a time at safe pressure. If your system lacks a clear blow-out port or you are not confident, hiring a pro once is a reasonable call.

Data: NOAA 1991–2020 normals via St George, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.