FrostList

When to Winterize Sprinklers in Spokane Valley, WA

ON TRACK108 days until first 28°F freezeOct 27

Spokane Valley's deadline to winterize your sprinkler system is October 17: the local first 28°F freeze runs October 27 on average and October 11 at its earliest (1991–2020 normals). Plan for the early end: the one-in-ten date lands about 16 days before the median.

OUTLOOK

Typical first first 28°F freeze near Oct 27; local deadline about Oct 17. The live 10-day outlook loads here.

Local freeze dates for Spokane Valley

ThresholdEarly (1-in-10)MedianLate (9-in-10)
32°F (light freeze)Sep 30Oct 15Oct 31
28°F (hard freeze)Oct 11Oct 27Nov 13
24°F (severe)Oct 21Nov 8Nov 26

NOAA station: Spokane Felts Fld · 3.9 mi away · 1,953 ft elevation.

For Spokane Valley, the nearest NOAA station with freeze data is Spokane Felts Fld, 3.9 miles out at 1,953 feet. Median first-freeze dates there run 32°F by Oct 15, 28°F by Oct 27, 24°F by Nov 8. Year to year the 28°F date has ranged from Oct 11 to Nov 13 — about 33 days apart. Spring's last 32°F freeze clears around Apr 26. Snowfall averages 45 inches a year, first reaching an inch near November.

Spokane Valley usually sees its first 32°F night about Oct 15, with the first 28°F hard freeze close behind near Oct 27. That first freezing night has ranged from Sep 30 to Oct 31, roughly a 31-day spread. On the spring side, the last 32°F freeze clears around Apr 26 and as late as May 10 — the green light for reopening water and de-winterizing. Snow totals near 45 inches a year mean plowing and ice-dam control share the winter to-do list here.

Your sprinklers checklist

  1. Shut off the irrigation water supply at the main valve and, if you have one, the dedicated sprinkler shutoff inside the house.
  2. Turn off the controller or set it to the "rain" mode so valves do not open while the system is dry.
  3. Drain the mainline using the manual, automatic, or blow-out method your system was built for; most pros prefer a blow-out.
  4. Connect a compressor to the blow-out port through a proper adapter and run 40–80 psi, one zone at a time, until the heads mist and clear.
    Helpful gear: Air compressor blow-out adapterRecommended pick
  5. Insulate the backflow preventer and any above-ground valves; this brass assembly is usually the first part to crack.
    Helpful gear: Insulated backflow preventer coverRecommended pick
  6. Cap outdoor hose bibs with foam covers after the hoses come off so the last exposed fittings stay protected.
    Helpful gear: Foam outdoor faucet coversRecommended pick
  7. Open the backflow test cocks a quarter turn so any trapped water has room to expand.
  8. Log the date and the psi you used; you will want the reference next fall.

What to have on hand

Air compressor blow-out adapter
Quick-connect fitting that mates a shop compressor to your irrigation line.
Recommended pick
Insulated backflow preventer cover
Pouch that shields the above-ground backflow valve from early frost.
Recommended pick
Foam outdoor faucet covers
Slip-on domes that protect hose bibs after you drain them.
Recommended pick
Portable air compressor
A modest pancake unit moves enough air to clear most home zones.
Recommended pick

What this means locally

Spokane Valley freezes close to Spokane (Oct 27) and about a week ahead of Coeur d'Alene (Nov 1) — a reminder that even nearby towns differ by days. Statewide, Washington prep dates run Oct 6 through Dec 1, which is why Spokane Valley gets its own number rather than a Washington-wide average. The same freeze also decides when to protect your indoor pipes and winterize an RV if you own one.

Other winter jobs in Spokane Valley

Every task below is dated to Spokane Valley's own freeze and snow normals.

See the full Spokane Valley winter checklist, in order →

Frequently asked questions

What temperature freezes sprinkler pipes?
Standing water in shallow lines and the backflow assembly can start to freeze once air temperatures drop into the mid-20s for several hours. Buried mains are slower, but the exposed brass backflow preventer and above-ground valves are the parts that crack first, which is why the deadline is tied to the first 28°F freeze, not the first frost.
Do I need to blow out my sprinklers or just drain them?
It depends on how the system was installed. Manual or automatic drains work if the lines were pitched to low points. Most irrigation pros recommend a compressed-air blow-out because it clears water that drains miss, especially in flat yards. If you are unsure how your system drains, a blow-out is the safer choice.
What happens if I don't winterize my sprinkler system?
Water left in the lines expands as it freezes and can split the backflow preventer, crack valves, or break fittings. Repairs to a backflow assembly commonly run more than the cost of a blow-out. The damage often is not visible until you turn the system on in spring and find leaks.
How much does a sprinkler blowout cost?
A professional blow-out typically costs somewhere in the range of a modest service call, depending on the number of zones and your region. Buying an adapter and using your own compressor costs less over time, but you need enough air volume to clear each zone. Prices rise once the first freeze warnings appear, so book early.
When should I turn my sprinklers back on in Spokane Valley?
Wait until the last spring freeze has passed, which averages around Apr 26 here in the 1991–2020 normals. Turning the system on too early risks refreezing a charged line. Open the main slowly to avoid a pressure surge, then walk each zone to check for winter damage before you rely on the schedule.
Can I winterize sprinklers myself?
Draining and insulating are within reach for most homeowners. A blow-out is doable if you own a compressor that moves enough air and you use a proper adapter, working one zone at a time at safe pressure. If your system lacks a clear blow-out port or you are not confident, hiring a pro once is a reasonable call.

Data: NOAA 1991–2020 normals via Spokane Felts Fld, live outlook by Open-Meteo. Sources · Methodology. Last updated: July 11, 2026.